CIRCUIT BREAKER

Inquire Now

professional in producing all kinds of Circuit breaker and Ac Contactor and Switch… more than 20years !

18mm width STRO-40L 6KA single phase RCBO Circuit Breaker 1P+N IEC61009 Electrical type up 60A

STM7-LE Series residual current circuit breaker with overload current protection is in conformity with the standards of IEC61009.It can cut off the fault circuit immediately on the occasion of shock hazard or earth leakage of trunkline.Thus it is suitable to avoid the shock hazard and fire caused by earth leakage.It can be used in circuits up to single phase 230V,three phase 400V,50 or 60Hz.

Normal working & installment conditions
1. Ambient temperature: -5oC~+40oC, 24 hours average temperature not exceed +35oC.
2. Installment plance altitude: ≤2000m
3. Gas relative humidity:not exceed 50% at +40oC, higher humidity allowed at lower temperature.
4. Pollution degree: 2 class
5. Installment condition: Mounted in the place without obvious impact or shock, no dangerous(explosion) dielectric without corrosive metal or damaging isolation gas(conductive dust).
6. Installment method: TH35-7.5 mounted rail, can be installed in distribution board, case or box. Generally mounted vertically. Tilted angle between mounting face and vertical face not exceed ±5°.
7. Mounted Category: II,III class.

Sandard IEC/EN61009-1
Electrical
features
Type(wave form of the earth leakage sensed) Electro-magnetic type, electronic type
Rated current In A A,AC
Poles P 2
Rated voltage V AC 120/240V; 240/415V
Rated Current : 10,16,20,25,32,40A
Rated sensitivity I△n A 0.01,0.03,0.1,0.3,0.5
Insulation voltage Ui V 500
Rated residual making and
breaking capacity I△m
A 630
Short-circuit current I△c A 6000
SCPD fuse A 6000
Rated frequency Hz 50/60
Pollution degree 2
Mechanical
features
Electrical life t 4000
Mechanical life t 10000
Protection degree IP20
Ambient temperature
(with daily average ≤35℃)
-25~+40
Storage temperature -25~+70
Installation Terminal connection type Cable/U-type busbar/pin-type busbar
Terminal size top/bottom for cable mm2 25
AWG 18-3
Terminal size top/bottom for busbar mm2 25
AWG 18-3
Tightening torque N*m 2.5
In-lbs 22
Mounting On DIN rail EN 60715(35mm)by means of fast clip device
Connection From top and bottom

Product Inquiry Form